Here in Britain, our structure of a number of beautiful models and drawings directly on the ceiling and walls for the use of tools like the fingers, hand towels, sponges, mops, brushes, etc. Trowel: Your only limit is your imagination, but in this article, I want to talk about the use of texture, ridges, a few incredible impact on your interior surfaces that are very reasonably priced and generally available through the Internet, plus ways to use texture coatingdesired surface is usually coiled, sometimes brushed, or "trowel in order to be sprayed."

As you can imagine, the cost of using the coating texture on the ceiling and walls in this way allows the home DIY enthusiast for a go myself, "because all you need is a bucket mix the powder in the plot, tool (or a mixture of an attachment for power drill or a plastic texture mixing tool that connects to a wooden handle,) texturepowder, a roller and a tray for mixing and, of course, the team comb texture;

Some texturing process chamber consists of a cast, all in one "design (almost like a plastic spatula mortar tile, but the scallops' scallop edge 'is a little' closer together / not long intervals), while we, the handle, and thanked (edge) reason consists of a molded, plastic, the normal length of the hill is about 10 cm in length (it is ideal for creating custom modelsTheir larger and low ceilings and walls), while others texturing combs consist of a wooden handle with a slot cut through it, while a piece or two of flexible plastic (which is the subject serrated edge), place texturing ridges fit correctly can serve you for a long time, but be aware, was done out of the combs in hot water as this could reduce the jagged edges, it is well to remember that even after many textures of the surfaces, the margin serrate canbecomes completely worn out, resulting in a more subtle side of the model more depth;

Following the model of the ceiling first, make sure the surface is properly sealed and that the room is cool (no heat), mix consistency should be sufficient to cover the entire surface to be structured, second, in deciding the model / project you want to find, is located at the desired room and looked at the ceiling, it is normal reallyearly pattern along the wall, ran across the width of the limited ceiling, overlooking the entrance, (but all depends on your personal preferences or the customer '.)
So, for example, we say that we will start our design of the entrance wall (when finished) will be the end of the longer (and stronger) the length of the ceiling.
Stand with your back against the wall (which is expected to start the pattern) &so this is the way to work the pattern as you design the model is always behind you, and work away from and across the narrow width and the length of the roof, now with their backs against the wall, the hand of the comb believes that the most convenient for the use of texture to keep if you hold the comb in your left hand, move through the wall in a corner of the right side of the room is the angle when you use your band with your textureTo start using the model to comb, and run the width of the wall / EDGE if you use the right hand, starting from far left corner of the ceiling.

In short, use the paint roller, roll on a band of texture, about half of the third quarter inches in depth thickness / the other side of the narrower width of your ceiling above the band edge of a wall on the other side of plot surrounding two roles widths range pattern with the comb and then continue with this method in its entiretyon the ceiling, always the right length of the field.
Everything here is completely covered in 'Texture Revival, "to help more, check my articles on texture blending and preparation of surface.

If you try to work through something, always the practice in a small area first to obtain the best results.
Thanks for reading, I hope this article will help you with your research to learn how to use combs with texture.

Dale Above tone.